Most recent activity
-
**Works again **
The B-7000 glue is easy to apply & has a good viscosity to stay in place - after placing LCD into position an elastic was used to keep it fixed for 12 h.
Lets see if loosening the screw helps - in case connection gets lost again - to move the PCB by the your instructions Gordon but without the need to remove LCD -
I loosened the screw above the bluetooth contact and that made the magic; could it me the cause Gordon that this was tightened to hard in production ?
-
I managed to disassemble using the heatbed on my 3D printer as recommended; how do I clean the contact as after reassembling I still get the bluetooth only connecting by hard squezzing. Thanks !
-
Hi Gordon run into the same problems again so I will go for disassemble - what glue should be used to fix the display back in place afterwards? Cheers Gernot
-
Thanks Gordon - hard squezzing and some hard taps on the side brought it back to connect with bluetooth 😃
-
Hi Gordon it does work in desktop mode 💪🏼
-
On iPhone I try to download via WebBLE the gpx file. After downloading I have no clue where to find it. Thanks 🙏
Having Bluetooth problems as well; pinching did not do the job- I was successful with disassembling earlier and thought i would just need to repeat it. The heat sensitive glue B-7000 that I used to reseal was easy to "unglue" again. So far so good.
Disassembled, did move the contact between the PCB and BT antenna as las time but this time I do not get stable contact reestablished.
Any recommendation how to clean the contact? I did add a bit of aluminiumfoil in between but this did not help.
Can I add some solder to the PCB spring or how do you deform the PCB contact to make stronger contact?
or can I add conductive ink respectively graphite to keep the connection intact?
Cheers, Gernot