Most recent activity
-
Looks great
-
Update . 3d printed the small cradle. (Very nice) . Took about 1 minute of twiddling and got it to start charging . Then stopped then twiddle again and started back up . Question is the nail polish going to help or hinder the charge ?.
-
Cleaned ready for nail polish.
The photo highlights the copper but they are quite dull except for the left one. The 2 middle ones are non existent or just there. 🤞 -
Just took the watch off after a warm day . This photo is prior to cleaning ( I don't have nail polish yet , hoping to buy today) connecting the charger cable is getting a bit of hit or miss . Going to 3d print a holder to see if it is stable connection as jumps in and out of powering up. 😞.
-
As per my link http://forum.espruino.com/conversations/Â370766/#comment16305638
Update: connecting power is getting hit and miss. I have to "twiddle" the contract to get it to fire up . -
Hi Gordon. I got the watch a few weeks ago. It seems to charge ok.
Thanks for the response. -
Hi just noticed gunk on the charger points of my watch(pic1) .
Has not been near water ( I'm very careful) or any bad things . When I rubbed it with my finger bits of the copper seemed to of come off (pic 2)
Is it ok and what could be causing it ? https://ibb.co/DMvqNZg
https://ibb.co/XCJ8k5k
Think I did right for pictures.
Hi just an update. Have put the varnish on ( cleaned with isopropyl alcohol before) . As can be seen in the photo corrosion seems to be continuing but charging has not yet stopped , starting with a bit of a wiggle 🙂). Where is the atmosphere hole people talk about. I was a bit liberal with the varnish and didn't want to block the hole .