I guess I'll post this for others to find since I figured it out as I was making this post.
So despite making sure I don't execute at boot event after reset, I couldn't seem to clear my code from flash without doing E.setBootCode() which I understand might be problematic if my code crashes.
I solved the problem by re-flashing the firmware and it seems to have fixed it.
sometime pico have strange behavior too and crash with clean code.
reflashing take few seconds than trying to identify uncommon behavior in code is timeconsuming.
i downloaded last firmware to avoid low connexion :)
Don't worry about formatting, just type in the text and we'll take care of making sense of it. We will auto-convert links, and if you put asterisks around words we will make them bold.
For a full reference visit the Markdown syntax.
© Espruino, powered by microcosm.
Report a problem