I started with Espruino a couple of days ago, and I must admit it is a very fascinating technology!
Hopefully this question is in the correct category...
Via the python tool, it is possible to pass all kind of parameters:
/path/to/esptool/esptool.py --port /dev/ttyUSB0 --baud 115200 \
write_flash --flash_freq 80m --flash_mode qio --flash_size 32m
I was wondering if it is also possible to pass somehow these parameters (e.g. flash_mode) to the flash function of the EspruinoTools in NodeJs?
Thought that this perhaps should be specified in the Espruino.Config, but I don't think that any of those parameters can be used for this:
Hopefully somebody can give me the golden tip ;-)
Hi, I don't think EspruinoTools supports uploading new Espruino firmware to ESP32/ESP8266. The -f command is for uploading to STM32-based Official Espruino boards
Ok no problem. Thanks for your feedback!!
Don't worry about formatting, just type in the text and we'll take care of making sense of it. We will auto-convert links, and if you put asterisks around words we will make them bold.
For a full reference visit the Markdown syntax.
© Espruino, powered by microcosm.
Report a problem