You are reading a single comment by @lavamantis and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@lavamantis
So, probably my two best options are:
Option 1. Go with the ULN2003 and follow these instructions: http://www.espruino.com/ULN2003
It seems reasonably straightforward. The + / - wires on the motor seem to go in the pink area of that diagram. Although, I have no idea what this part means:
"Note: COM is connected to each output (1-7 C) via a diode. If you're driving inductive loads then you can connect it to the other side of the load being driven, and it will help to clamp the Back EMF generated when the load is turned off. For instance if you are powering your load from BAT, just connect COM to that."
Option 2. Use one of the MOSFET thingys. Is there a tutorial somewhere that shows what to solder to what, including where the motor wires go?
Thanks!