You are reading a single comment by @Andrey and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Andrey
I thought also, that installed GYRO chip on the board, connected to spi1 can disturb to communication, but its CS signal is in "1" what means that it disabled. And the registers look ok, all but RX_ADDR_P1 and RX_ADDR_P0. Supply of the NRF boards are ok (3.0V took from the F3 boards). NRF's are close to each other.