You are reading a single comment by @yngv126399 and its replies. Click here to read the full conversation.
    The board is easy to solder too, plus you get two buttons.


    I should add: I removed the original SQUARE display as it was cracked on delivery; that leaves the entire 12-pin array of solder points so if you can solder at 0.6mm you can get 3.3,GND,and 5 GPIOs (for the display CS,RST,SDA,SCL,DC). These are tricky and fragile solder points so I just used two here and secured them


Avatar for yngv126399 @yngv126399 started