You are reading a single comment by @fanoush and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@fanoush
It is marked in red on that wiki page https://github.com/joric/nrfmicro/wiki/Alternatives
search for "Workarounds". I just crush it in the middle with small flat screwdriver but could be desoldered too.
Also down on that page for nice!nano v1 "Regulator: AP2112K (code G3P, up to 600 mA, leaks 55uA), you can replace it with XC6220 (up to 1A, leaks 8uA)" so the voltage regulator leaks less than half of this cheap board. however if you power LED from it it draws much more anyway and if you need much less then the VDD pad could work (or GPIO pins).