You are reading a single comment by @ccchan and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@ccchan
hi,
i dig into you old post:
https://forum.espruino.com/comments/17031039/
you said:
"Although it is possible that by pushing the button gently and moving your finger around in circles you can bring it back to life, or you can connect with the Web IDE and type load() on the left-hand side to reload the Bangle's watch face without a button, so even without the button it could still be used as a temperature/pressure sensor or display of some kind - however unfortunately if it runs out of power or is turned off, there won't be a way to get it working again."
i just tried,
i just installed a new app, and then connect the banglev2 to webide and use load(), then i can bypass that "hold the button to reload app" screen.
now with the "pattern launcher", and "swipe back to clock", together with this load() trick,
provided i dont let it drain to 0 battery, i think i dont need to touch the button again.
thank you.
ps: if later can disable that screen from app loader,
it is good. but not urgent, thanks