You are reading a single comment by @remy and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@remy
As per subject, I've got a puck (I think from the kickstarter campaign way back), and when I half insert the (new) battery, it powers up fine and probing the 3V and GND test points gives me 3.00v off the battery.
But once I fully push the battery in, the voltage is around 0.2-0.4v - which explains why I couldn't connect to the Puck anymore.
It's visibly clean inside the Puck and barely used. The cell battery is clean too.
Is this a known (ideally fixable) issue?
Any ideas or advice would be much appreciated.
Thanks in advance.
4 Attachments