You are reading a single comment by @Alberich123 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Alberich123
The button of my bangle 2 from the Kickstarter campaign sometimes does not work properly.
The button was not reliable from the beginning, sometimes working good, sometimes only responding after special treatment (works better if pressure comes more from the back than from the side, ...). Fun fact: The behavior is not completely irregular. If the button works good, it stays this way for a while. Also if it's working bad, this also stays for a while, don't matter what i try to recover. Like some dirt flying around inside and sometimes blocking the button.
Sounds a bit like this thread: http://forum.espruino.com/conversations/370415/
I expected this to get better by time, or if not, i would have to open it and look after the button. Now id didn't get better, and looking closer at the watch i realized there is no 'easy to remove' back plate. Seems the watch must be entered from the front, removing the glass and then go forward...
Any idea how to open the device, or howto recover the button another way?