Firmware Version: 2v11.251
I just plugged my BangleJS2 into my computer after letting the battery drain after about a week of use(was polling from the pressure sensor, so I'd figure battery isn't going to last the whole 4).
However, shortly after plugging it in I glanced down at the watch as I had noticed it was on the setup screen on the last step which told me to press the hardware button to proceed.
I pressed the button and was brought to Anton Clock and everything had reset, I lost everything.
I want to see if I can figure out what happened and see if I can help contribute a fix to this. Lucky for me I had my projects I'd worked on backed up and the only annoyance is I have to reinstall everything.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Firmware Version: 2v11.251
I just plugged my BangleJS2 into my computer after letting the battery drain after about a week of use(was polling from the pressure sensor, so I'd figure battery isn't going to last the whole 4).
However, shortly after plugging it in I glanced down at the watch as I had noticed it was on the setup screen on the last step which told me to press the hardware button to proceed.
I pressed the button and was brought to Anton Clock and everything had reset, I lost everything.
I want to see if I can figure out what happened and see if I can help contribute a fix to this. Lucky for me I had my projects I'd worked on backed up and the only annoyance is I have to reinstall everything.