Bangle (original) won't restart after installing app

Posted on
  • Hi.

    I installed the Red Torch app on my Bangle.js (original), and got the "Hold BTN3 to reload" message. BTN3 did nothing. Neither did 1+3 return me to the clock.

    Neither does using 1+2 to restart, nor 1+2 and release 2 for a no-software restart. They display these messages:

    WATCHDOG
    DFV ZV05

    Then a new screen:

    Bangle (JS in a watch logo)
    2V09.79
    e6:ba:3e:fe:95:1e
    Copyright 2021 G. Williams

    The only thing it will respond to on that screen is the 1+2 forced reset. I'm about to use that to turn the thing off to save battery.

    I can connect using Bluetooth. I removed Red Torch. The Bangle displayed the same "Hold BTN3" message, and again holding BTN3 did nothing. Now "My Apps" in the web interface shows nothing. I promise I had apps installed.

    I followed the instructions here: https://www.espruino.com/Bangle.js#reset­ting-without-loading-any-code, installing default apps. This worked, and the system inexplicably installed my default apps. Aaaand ... BTN2 does nothing, I can't get to Setup or anything. And 1+3 ... makes the time jump ahead 5 hours, from correct to 5 hours fast?

    I tried installing a different launcher (the Desktop Launcher) but this did nothing.

    I know you'll say to install the latest firmware, so I downloaded it to my Android phone. The procedure (https://www.espruino.com/Bangle.js#firmw­are-updates) says to upload to a device named DfuTarg. There isn't one. Attempting to upload to the Bangle device (which is listed) results in the message, "Upload failed: DFU CHARACTERISTICS NOT FOUND".

    How to proceed?

  • That's extremely strange - but to update the firmware, the instructions you mentioned at https://www.espruino.com/Bangle.js#firmw­are-updates say:

    • Long-press BTN1 + BTN2 for about 6 seconds until the screen goes blank
    • Release BTN2
    • Release BTN1 a moment later while ==== is going across the screen
    • The watch should now be in Dfu mode

    I think you missed those steps. When in DFU mode the display should show DFU START in the blocky font, and I bet yours had booted back up to a clock face or the Bangle.js logo?

  • @Gordon, thanks. You were completely correct. It's working now.

  • Great - glad you got it sorted!

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

Bangle (original) won't restart after installing app

Posted by Avatar for CarlF @CarlF

Actions