You are reading a single comment by @c.l and its replies.
Click here to read the full conversation.
-
Fri 2021.07.23
Hi @user132338 , Nicely outlined, smart, detailed and covers all scenarios.
I remembered reading this has occurred before and found the last entry Gordon had made:
I Googled: 'bangle reboots after firmware update site:espruino.com'
Has holding down all three buttons been attempted?
Until Gordon returns from Holiday, this was the last recovery attempt solution I had read about.
Bangle.JS Watch
Original version, pre-loaded at Kickstarter purchase: 2V.05
Error: Infinite boot loop.
Details: After FW update the watch remains at the following screen:
Sw Reset
DFV ZVOS
Booting...
BTN1 = Reboot
Connect
Rebooting whole holding BTN1 brings me to the screen:
Watchdog
DFV ZVOS
Booting...
BTN1 = Reboot
TROUBLESHOOTING
Resetting without loading any code: Cannot get the Bangle.js logo/ersion/MAC and following the next step doesn't work as it's what I was already doing: https://www.espruino.com/Bangle.js#firmware-updates
Attempted similar troubleshooting as this post: http://forum.espruino.com/conversations/346380/
This as well follows the Deleting All Code instructions on the troubleshooting section.
Bangle.js is NOT cannot be paired to the computer or phone as it can't be located.
Attempting to roll back using the same methods does not work and produces the same results.