-
• #2
I checked voltage w meter and it's around 4.5, which I believe should work, no?
-
• #3
Man this is embarrassing again, but 4.5V is not enough. I was able to get 5.2V or so and now it works.
-
• #4
It has to do with misplaced voltage regulator, but basically, blue light flashing is the behavior when u arent properly powered.
-
• #5
It has to do with misplaced voltage regulator
Misplaced regulator on the Espruino board? I imagine most likely what happens is as soon as the WiFi powers on it draws so much power it cases a reset
-
• #6
No its a bad regulator coming from the PS on my side. I used the autolocator all day in a session yesterday and it's running pretty well!
-
• #7
Interface is not right. But it's working pretty well.
1 Attachment
-
• #8
That's great! Glad to see it working nicely :)
I've been able to get a bunch of stuff to work from the IDE => RAM, then I figured out how to get it going properly from USB (no computer/IDE) by removing onInit(); and using save() command. So yeah, that works when powered over USB cube.
However, when I apply 5V to the VUSB pin, it just flashes a blue light on and off... Not sure why it works in all circumstances but this?
Thoughts?
Thanks!
Matt