You are reading a single comment by @Robin and its replies.
Click here to read the full conversation.
-
Sun 2020.02.09
@rethus, what is the WebIDE Baud Rate set at?
WebIDE >> Settings >> Communications >> Baud Rate
and
WebIDE >> Settings >> Console
might reveal some much needed detail. . . .
Confirming'download and unpack this Package'
Which device was selected? The link in post #7 only points to the download page.
@Frida Thanks a lot for your step-by-step introduction.
I've now
If I start the ESPruino Web-IDE and connect the Chip, I see that the Chip output something... all the time:
But uploading the example-blink-Script doesn't work. Returend Prompt not detected - upload failed. Trying to recover...
If I do the following:
esptool.py --port /dev/ttyUSB0 --baud 115200 write_flash --flash_freq 40m --flash_mode qio --flash_size 1MB 0x0000 "boot_v1.6.bin" 0x1000 espruino_esp8266_user1.bin 0xFC000 esp_init_data_default.bin 0xFE000 blank.bin
So what I've done wrong?
BTW: I didn't found the place to change Baud-Setting in Chrome-Web-IDE.