You are reading a single comment by @Robin and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Robin
@allObjects,
Hello Markus, i've tried to add a diode N4007 to sda and scl... (as you explain) it's worse, it does not init.
The module have 2 10k resistor in pull-up on sda and scl.
is it possible to remove the resistors or change value to a 4k7?
i refer to an other post here
regards
é.