You are reading a single comment by @Oscar and its replies.
Click here to read the full conversation.
-
Fri 2020.01.03
'I have no idea what helped but thanks again for all the inpu!'
@Oscar, it was mentioned that setWatch() and setInterval() were being used for testing. Could it be that code snippets (after each test) were being uploaded on the Left-hand Console side, after at least one upload of an existing code file, using the Right-hand editor side? my comment will be based on the response
Robin
@Oscar
Well guys:
I did a hard reset of the board, erased the saved code, did not physically change anything on the circuit but it is now working, that is, digitalRead can sense touches on the board.
I have no idea what helped but thanks again for all the inpu!
Oscar.