You are reading a single comment by @DamianMontero and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@DamianMontero
It looks like the Pixl.js did get damaged.
I threw the badge and left for my conference and here I am and the system boots up. the ESP8266 flashes once quickly blue (so it has power) and then a second later blinks a couple of times (as if it's connecting and retrieving information) and then just stops and never flashes again
and I get "Uncaught no 'ready' after AT+RST"
so it means the board doesn't reply. or it's not communicating the information back to the pixl.js
I measure the power on the Vcc and ground and I get 3.2 while it's booting up and then zero. (like the pixl.js has turned it off or grounded it.
any advice?