You are reading a single comment by @user103487 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Robin
@user103487
I had to remove the header.
I then soldered the trace back down, it seems I had previously melted/burnt it out... don't ask.
In the end I just soldered some jumper wires directly to 3v and gnd and it works fine.
I would still like to know how I would go about attaching a lipo battery connector and where that could best be achieved.