You are reading a single comment by @mports and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@mports
Having had my Pixl.js (updated to 2V03) for just over 24hrs it's fair to say I'm still very much learning. Having played around a bit, I used the save() function to write to the flash.
However, I'm now unable to clear out the saved code by performing a 'hard reset' (as per the instructions) by pressing BTN 1 for ten seconds; as it simply doesn't appear to work.
Holding BTN 1 for ten seconds does absolutely nothing, at no point does my Pixl.js display 'Removed saved code from Flash'. Upon removing & replacing the battery the original saved code reboots.
BTN 1 is functioning correctly as I'm able to turn the toggle the backlight on and off.
Any suggestions as to how I perform a hard reset to clear the flash?
Kind regards,
Mark