Espruino Pico onInit problem

You are reading a single comment by @allObjects and its replies. Click here to read the full conversation.

•

allObjects

After upload, did you a) run it and then save it? - or b) save it right away?

Save will after completion call onInit, can you verify that?

I 'm sure you already worked through the Troubleshooting section...

•

Pinnchus in reply to @allObjects
After upload, did you a) run it and then save it? - or b) save it right away?
I have tried both options.

Save will after completion call onInit, can you verify that?
Yes it does, in fact while connected it works very well. The problem happens when I connect it without a console, but in the code I do not have any call to write to the console.
```
Compacting Flash...
Calculating Size...
Writing..
Compressed 81600 bytes to 19967
Running onInit()...
```
if force the running mode with load(), works ok...
```
>load()
=undefined
Loading 20034 bytes from flash...
Running onInit()...
```
I 'm sure you already worked through the Troubleshooting section...
Yes I did but without success.

Thanks for your help.

About

Avatar for allObjects @allObjects started