You are reading a single comment by @Robin and its replies.
Click here to read the full conversation.
-
Sun 2018.07.29
re: "I ordered the Raytac MDBT42Q BLE Module and I am planning to put
a breakout board together once I receive it."and pre-installed Espruino from an authentic breakout board wasn't the preferred choice because . . . .?
https://shop.espruino.com/mdbt42q-breakout
Technical MDBT42Q Bluetooth Module
http://www.espruino.com/MDBT42QExpect MDBT42Q-breakout boards available on Amazon N.A. around mid August 2018
Robin
edit:Found this regarding bootloader: Flash a new MDBT42Q with Espruino Mon 19th, March 2018
Robin
@ConorONeill, I am going the same route as you. I ordered the Raytac MDBT42Q BLE Module and I am planning to put a breakout board together once I receive it.
Q#1: Which binary should I use?
Q#2: Is the bootloader shipped with the firmware provided by Espruino?
Q#3: What software did you use to flash the firmware on yours? (I have Segger programmer)
A little background, I built prototypes before and programmed BGM111 directly using Simplicity Studio but I got very interested in using JS instead of C.
Thanks