You are reading a single comment by @gendor and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@gendor
It is a really tight fit in terms of assembly - I had to use a flat screwdriver to lift the corners in order to get them to close. Would one clip per corner instead of two maybe be sufficient?
I actually had to print the top part a second time, as it delaminated from the print bed at the corner where the logo is. This is mostly my own fault, as the first layer height wasn't calibrated correctly, but on the second print (with correct first layer height) it still lifted up from the bed a little bit. Maybe this could be resolved by moving the logo to the left by a small amount?