You are reading a single comment by @lloydwatkin and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@lloydwatkin
Using a system very similar to http://www.espruino.com/Heater+Controller
I can see the relay is being switched on and off because I se the IN1 flashing in time with LED on my pico.
However I get nothing from the motor. If I connect the motor across the battery terminals is goes like crazy.
If I move the yellow cable from pin 3 (? leftmost of K1) to pin 1 the motor goes like crazy but there's no switching it off.
I'm clearly going wrong somewhere very simple, little help? Thanks, Lloyd.
2 Attachments