You are reading a single comment by @swaroop and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@swaroop
I've got 2 Node MCU ESP8266's and I believe both of them are a 12E too. I dont have a link to share as i bought them off from a local store.
But on one, i have the Amica branded one (the other one was a GPIO chart behind, no brand). which mentions "Use 9600 baud rate"
I was able to program these two devices in Arduino IDE and work with various sensors too.
About Espruino Web IDE, i have the same behavior as you described above. Not responding.
i'll look for the older boot_v1.5.bin. Perhaps these should be a part of the Older Espruino releases v1.87 ?