-
not work, after save(), log is printed. but reset the board, cannot see the hello string except boot messages.
function setup_sim800c() {
console.log("Hello, SIM800C!");
}function onInit() {setup_sim800c();}
save()
=undefined
Erasing Flash..................
Writing.....
Compressed 80000 bytes to 3010
Checking...
Done!
Running onInit()...
Hello, SIM800C!
ets Jun 8 2016 00:22:57
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
ets Jun 8 2016 00:22:57
rst:0x10 (RTCWDT_RTC_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0x00
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0008,len:8
load:0x3fff0010,len:1932
ho 0 tail 12 room 4
load:0x40078000,len:10012
load:0x40080000,len:252
entry 0x40080034
ERROR: jswrap_wifi_restore: esp_wifi_connect: 10
Loading 3010 bytes from flash...
You are reading a single comment by @user81716 and its replies.
Click here to read the full conversation.
user81716
...try with the 'old'
onInit() { setup_sim800c(); };. If this does not help, defer the invocation of setup_sim800c() with a setTimeout(). Since nothing is printed, I'm not sure where the print goes... can you flash some LED on a pin?