GPIO Pin BTN LED naming conventions specific to ESP8266

You are reading a single comment by @MaBe and its replies. Click here to read the full conversation.

•

MaBe

Hi Robin,

mode is a string, so use 'input_pullup'

pinMode(D4, 'input_pullup');

or set input_pullup

input_pullup = 'input_pullup';
pinMode(D4, input_pullup);

•

Robin in reply to @MaBe
Thr 2017.02.02

Good catch. I must have had a senior moment. That saved me a few hours of hair pulling of whats left. Thank you @MaBe

I knew I had seen the syntax on this site without the quotes, but I must admit I missed this from the Espruino Reference page

mode - The mode - a string that is either . . .

mind stuck in 'why doesn't this argument work now' mode and just didn't get back into gear for the basics. It should have dawned on me to create a variable from the literal to become compiler compliant. nasty accuracy checker. ;-)

Note: digitalRead/digitalWrite/etc set the pin mode automatically unless pinMode has been called first.

Now with the syntax corrected, this error pops up for the 'input_pulldown' on the ESP8266
```
ERROR: Pin state not supported
```
This only occurs on pulldown but pullup functions as expected.

Since I haven't seen documentation detail on 'input_pulldown' for the ESP8266, may I AssUMe that the Espruino Reference documentation is for Espruino boards only; the compiler is accurate and that the ESP8266 module doesn't have this feature available?

About

Avatar for MaBe @MaBe started