load()

Now I learnt to use 'load()'.

on PICO

>reset();
=undefined
 _____                 _
|   __|___ ___ ___ _ _|_|___ ___
|   __|_ -| . |  _| | | |   | . |
|_____|___|  _|_| |___|_|_|_|___|
          |_| http://espruino.com
 1v91 Copyright 2016 G.Williams
>
=undefined
>load()
=undefined
No code in flash!
> 

on ESP8266

>reset();
=undefined
 _____                 _
|   __|___ ___ ___ _ _|_|___ ___
|   __|_ -| . |  _| | | |   | . |
|_____|___|  _|_| |___|_|_|_|___|
          |_| http://espruino.com
 1v90.38 Copyright 2016 G.Williams
Espruino is Open Source. Our work is supported
only by sales of official boards and donations:
http://espruino.com/Donate
Flash map 512KB:256/256, manuf 0xe0 chip 0x4014
>load()
=undefined
No code in flash!
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet
ERROR: Not connected to the internet

It continues ultil I reset, or power off.