I've successfully recorded some IR commands and played them back via Puck.IR, but I need to hold the Puck very closely to the receiver. Is there a way to increase the reach of the IR LED?
If not, what is the recommended way yo create a multi IR-LED panel with increased power/reach? I would like to send the same signal via multiple IR leds, if possible in each direction (like a roudn panel and every few degrees a new IR LED). Has someone done this before?
Hey, @hansamann. One thing that occurred to me was leaving the IR Puck nearest your receivers, then using BLE to talk to that Puck from either
But adding a 5mm IR LED is probably a better bet. @Gordon, what's the recommended maximum mA draw for such an LED?
© Espruino, powered by microcosm.
Report a problem