Load program after reset or power-on ESP-8266 12f

You are reading a single comment by @MaBe and its replies. Click here to read the full conversation.

•

MaBe

o setup wifi as station connected your access point (only once)

var Wifi = require("Wifi");
Wifi.connect( "your SSSID",{password:"your password"}, function(err) {
    if (err) {
        console.log("error connecting to your SSID:",err);
    }
    else {
        Wifi.stopAP();
        Wifi.setConfig({powersave : "none"});  // optional    
        Wifi.save();  // this saves all your Wifi settings
        console.log("Wifi.getIP:", Wifi.getIP());
     }
}

o write code you want to be started on boot='init' and upload

E.on('init', function() {
	  // add your code here
	  ......
});

o after your code is completely uploaded run save, this will save, restart and run your code


save();

•

jakub.frydrych in reply to @MaBe

Hi, thaks for answear.

I test this tip and after restart device ( use func reset() ), device not loaded code from init function. What I do wrong ?

Testing code for init func :

E.on('init', function() {
      console.log("Device started");
});

And console output, after save(); code correctly loaded, but after reset() not load code from init function. If I call load() func after reset, code correctly run.

Connected
>
>
=undefined
Wifi.getIP: {
  "ip": "10.0.0.42",
  "netmask": "255.255.255.0",
  "gw": "10.0.0.138",
  "mac": "5c:cf:7f:24:77:e4"
 }
>
=undefined
>
=undefined
Erasing Flash.....
Writing....
Compressed 27200 bytes to 2026
Checking...
DDevice started
>reset();
=undefined
 _____                 _
|   __|___ ___ ___ _ _|_|___ ___
|   __|_ -| . |  _| | | |   | . |
|_____|___|  _|_| |___|_|_|_|___|
          |_| http://espruino.com
 1v89 Copyright 2016 G.Williams
Espruino is Open Source. Our work is supported
only by sales of official boards and donations:
http://espruino.com/Donate
Flash map 4MB:512/512, manuf 0xe0 chip 0x4016
>

Load program after reset or power-on ESP-8266 12f

About

Espruino