You are reading a single comment by @Wilberforce and its replies.
Click here to read the full conversation.
-
I tried changing the pin designation, but i get no change at all.
When i change the CS pin to pin 5 i get no "sd card" error except 'connection lost' in the terminal window.
i tried every possible pin combination. with and without the Nodemcu.D..
my wiring is correct because i have used the sd card in the arduino IDE and that works just fine.
ManoBiletsky
@Wilberforce
Have a look here:
http://forum.espruino.com/conversations/285779/#comment13002694
There might be some clues on how to setup your wiring..
The
Nodemcu:D4type set up may help instead of just using D4 if you are going by the labels on the board...