• This is what I get every time I try to setup the I2C, it just dumps this data and resets:

    >I2C1.setup({sda:D4, scl:D5, bitrate:100000});
     ets Jan  8 2013,rst cause:2, boot mode:(3,6)
    load 0x40100000, len 1396, room 16
    tail 4
    chksum 0x89
    load 0x3ffe8000, len 776, room 4
    tail 4
    chksum 0xe8
    load 0x3ffe8308, len 540, room 4
    tail 8
    chksum 0xc0
    csum 0xc0
    2nd boot version : 1.4(b1)
      SPI Speed      : 80MHz
      SPI Mode       : QIO
      SPI Flash Size & Map: 32Mbit(512KB+512KB)
    jump to run user2 @ 81000
    ã4ýXÑ128=0x80000
    ãìgäsón|ä$l`ãsll
     _____                 _
    |   __|___ ___ ___ _ _|_|___ ___
    |   __|_ -| . |  _| | | |   | . |
    |_____|___|  _|_| |___|_|_|_|___|
              |_| http://espruino.com
     1v86.tve_master_247bc37 Copyright 2016 G.Williams
    Espruino is Open Source. Our work is supported
    only by sales of official boards and donations:
    http://espruino.com/Donate
    Flash map 4MB:512/512, manuf 0xe0 chip 0x4016
    
About