You are reading a single comment by @sp33c and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@sp33c
I could successfully switch a HM-10 BLE Device with the 5LN01SP (using a IOPin for Gate). However only with VBAT to source (Espruino was hooked up with USB => 4,5V?). the 3.3V pin does not work, when switching with a IO-Pin at Gate. the current seems not high enough. Is there a way to use 3.3V, e.g. use two MOSFETS in parallel?