You are reading a single comment by @unknowndomain and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@unknowndomain
I've just updated my perfectly working board to this because the IDE advised it, and then used save() to flash the code I wrote to the board, and now the board is no longer showing up in the USB list on the IDE and when I use various cables to get into bootloader mode I get a blue solid and red light which occasionally pulses blue then goes red and blue solid and bright...
I really don't know what is wrong or what to do, there is no record of this issue happening before, but I am really up s*** creek right now.