I also changed that NC (not the one on the power - that's now NC/Vin), the one that would connect to B3 on Espruino) to connect to reset, some other people on that forum were saying they found reset pin to be useful. So there it is.
Mounting holes.
Longer pads for easier soldering.
Pads on the bottom for a regulator and caps.
Better silk, labels on the antennae
TX and RX now line up correctly for pico
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Order placed!
I also changed that NC (not the one on the power - that's now NC/Vin), the one that would connect to B3 on Espruino) to connect to reset, some other people on that forum were saying they found reset pin to be useful. So there it is.
Mounting holes.
Longer pads for easier soldering.
Pads on the bottom for a regulator and caps.
Better silk, labels on the antennae
TX and RX now line up correctly for pico
Ordered plenty of them this time too.