You are reading a single comment by @JumJum and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@JumJum
Would it be an option to take first layout and move the pins down to the end of the board ?
Then move labels up the place where pins are right now.
This would give an option to those working with breadboards using 2 of them.
A big one for pins 0-14, and a small one turned by 90 degrees for other pins.
Labels would still be readable on the board this way, and you could use breadboards.