You are reading a single comment by @d0773d and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@d0773d
Where I have written ESP8226 I meant to write ESP8266, oops. The baud rate is 9600 :). I'm still getting the Uncaught No 'ready' error. I then tried to communicate directly to the shield via an FTDI and termite(serial terminal). I have the auto line termination set to carriage return and new line. The only command I can get an OK back is AP any other command I send to it results in an ERROR.
I sent off a bunch of ESP v2 shims to oshpark and ordered a bunch ESP boards from sparkfun. Hopefully my luck will change once I receive those in the mail.