You are reading a single comment by @errantspark and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@errantspark
I've done my best to get it to work but it doesn't seem like it's functioning correctly. I used DfuFileMgr.exe with the multi BIN option to write the *.bin I downloaded to a *.dfu file. (address 0x0800000) and then I wrote the DFU file using the DfuSe Demo. Plugging the board in causes the red led to flash briefly now which wasn't happening before, and once I'd removed the graphite bridging the pins on the back plugging in while holding down the button results in both the red and green leds going on continuously. Unfortunately the board doesn't seem to be detected in either case. : (