You are reading a single comment by @alexanderbrevig and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@alexanderbrevig
Oh my... what to do? It should've been milled through but it's only engraved...
I got this:
I chose the cutter tool as opposed to engraving from their software as per my screenshot. Anyone got any experience with Schaeffer Front Panel Designer?
Do you think it's possible to get an OK result using a routing bit and a hand drill? :|