You are reading a single comment by @Coder2012 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Coder2012
I got it working, I have both the Espruino v1.4 and the Pico. I'm using the Pico in this case. After re-soldering the pins I got the green light on the CC3000 (thanks for the 5V tip!) but still no connection.
The issue was I had just assumed that B3 - B8 were all along the same edge, after checking the diagram closely on the ref card I got with the Pico, I noticed my mistake and once I connected B8 it all worked without a hitch!
Could I just ask, what's the best way to connect wires to those smaller points on the short edge of the Pico? I'm using the jumper wires but the holes on the edge are tiny so I can't put a pin in there.