You are reading a single comment by @LawrenceGrif and its replies.
Click here to read the full conversation.
-
See page 106 for ST's specs:
http://www.st.com/web/en/resource/technical/document/datasheet/CD00191185.pdf
See page 106 for ST's specs:
http://www.st.com/web/en/resource/technical/document/datasheet/CD00191185.pdf
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
DrAzzy
@LawrenceGrif
What should I expect as output voltage when writing 1.0 on the Original board?
I'm only getting 3.14 and the 3.3v supply is only 3.2v.
Same as I'm going to have to put an wee amp to get to 3,3v.