You are reading a single comment by @Deas and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Deas
Hi, I think I might have broke the pico I received a few days ago.
I was attaching the pico to unsoldered wires on GND and VCC (or was it 3v?) and an error messaged appeared on my macbookair saying that usb was drawing too much power and it did something about it (i didn't look, as it was very similar to another error I receive often with my prettymuch constantly attached SDcard randomly disconnecting), and after that the pico does not seem to react on inserting (that quick red led blink) nor showing up on serial port.
Holding down the button on trying to go into bootloader does not respond either.
I've tried rebooting to no vail.
suggestions?