You are reading a single comment by @alexanderbrevig and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@alexanderbrevig
The first reflow is done!
As you can see there are a few solder bridges, I this happened when I lifted the stencil. The PCB followed with it (damn you surface tension!) and I think it skewed the solder blobs some. I'll tape the PCB down the next time around.
I think I can fix those with solder wick and the iron though. Just wanted to show you the raw out-of-the-oven board.