You are reading a single comment by @Progma and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Progma
I would like to connect a load sensor and two Hall-effect sensors to my Espruino Board 1.4b. Does it matter where I connect the wires to on the board for a sensor that doesn't have a module?
Would it matter for the load sensor what area I connect it to on the board? The sensor has a ground wire and might need a specific voltage. Also with the load sensor, it will need to be converted to a digital signal (so I'm guessing an ADC spot) . I think voltages matter in an ADC conversion and the load sensor has the capacity of sensing up to 50kg. I'm also not familiar with the voltage conversion equation enough to really know what I need to do with the load sensor so that it senses up to the 50kg max.
If it also wouldn't be to much trouble, does anyone know a good setup that would work with a load sensor like the kind I have?
For the Hall-effect sensor, my main concern is using a resistor with the sensor. How would that work with the Espruino Board? And the resistor is needed.
Link to Load sensor page:
https://www.sparkfun.com/products/10245
Link to Hall-effect sensor page:
https://www.sparkfun.com/products/9312
Thanks in advance!