You are reading a single comment by @Espruino_user_dk and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Espruino_user_dk
Ok so I found some images where I could see where to attach the antenna - but it did not change much. I have used the same length as for the transmitter.
Could it be that both the transmitter and receiver is close to each other (would like to have both tx and rx functionality on same Espruino board) and thereby generating noise of some sort? In the tests I have not used the transmitter at the same time as receiver however both is powered.
Could it be I need thicker wire as of now I just use the thin wires that came along with my breadboard.
Thanks...