Just seen in another conversation, you are working to support ESP8266.
Please take care to new versions of firmware.
There are some interesting commands and changes:
commands need to be followed by /r/n, in older version /r only worked fine
AT+CIUPDATE is a command to update firmware from a cloud, if modul is connected to wifi
ATE0 switches echo off and ATE1 switches it on again. This can help, you don't have to skip echo anymore
Another new version, which I cannot get running is V0.922 which adds AT commands to change baudrate, changing default from 115200 to 9600 same time. There is another command for watchdog handling, but as said before I didn' get it running reliably.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Just seen in another conversation, you are working to support ESP8266.
Please take care to new versions of firmware.
There are some interesting commands and changes:
Another new version, which I cannot get running is V0.922 which adds AT commands to change baudrate, changing default from 115200 to 9600 same time. There is another command for watchdog handling, but as said before I didn' get it running reliably.