Avatar for caliskan

caliskan

Member since May 2015 • Last active May 2015
  • 0 conversations
  • 2 comments

Most recent activity

  • in General
    Avatar for caliskan

    Jack, on a hardware level, you need to ensure that you’ll be getting a fixed signal with no fluctuations in its analog values, you can do that by using an oscilloscope. Once you start writing your program, you can use ADC averaging or a moving average filter to get best possible results from your optical sensor. I’m planning to use this sensor in one of my circuits as well and I’m going to be waiting for your feedback.

  • in Electronics
    Avatar for caliskan

    DrAzzy, The work you’ve put into this board is nothing short of amazing. With the fix to power busses and through-hole size I believe this is one the best prototyping board out there. There are not square vias, but just in case, if you could put some square soldering pads on through-holes which could possibly indicate the pin 1 of any IC. You can place those after 10 or 20 vias in a line so that people can use those to indicate the first pin of their ICs.

Actions