You are reading a single comment by @d0773d and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@d0773d
I flashed the Espruino board down from 1v52r3 to 1v51r3. Downgrading the firmware I think fixed the >ERROR: Invalid baud rate specified I do not receive that error after submitting save(). However, I am still not able to get the code to execute upon the boards initial power-up.