Oh right, sorry! Ok, then no, none of what I said applies!
Likely what happens is the connector has come away from the board a bit then - so I guess you could try reflowing the solder for the connections at the end.
But yes, you could attach a USB-TTL dongle as shown at http://www.espruino.com/Original#advanceĀd-reflashing (minus the 'BOOT1' connection) and you can then program it pretty much exactly as you would normally. Or you could attach an HC05 bluetooth module
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Oh right, sorry! Ok, then no, none of what I said applies!
Likely what happens is the connector has come away from the board a bit then - so I guess you could try reflowing the solder for the connections at the end.
But yes, you could attach a USB-TTL dongle as shown at http://www.espruino.com/Original#advanceĀd-reflashing (minus the 'BOOT1' connection) and you can then program it pretty much exactly as you would normally. Or you could attach an HC05 bluetooth module